BCM-VG-KM-MOD-3-BLK : BCM® Vertical Grip - KeyMod™ - Mod 3 - Black

SKU

152698

Low-profile length for increased mobility and decreased "snag" factor.
The forward angle increases the rigidity of the forearm, while providing a more natural wrist angle.
Can be mounted in reverse angle to increase control when grabbing handguard and grip.
Flat sides with aggressive texture give better yaw control to the shooter during firing and non-firing manipulations.
Anchor and bolt system offers a simple robust design, while maintaining a lightweight 1.9 ounces.
Manufactured from high quality, impact resistant polymers.

Made in USA

Tools needed: T15 Torx Driver (not supplied)

Insert tool (T15 TorxT driver) into the screw from under the BCM® KeyModT Vertical Grip
Push tool into the screw to extend the KeyModT anchor, making it protrude from the top.
Align the anchors in the two selected large holes of the desired KeyModT slots. Grip can be installed in your
desired orientation, angled forward or back.
After the anchor is inserted, slide the BCM® Vertical Grip forward until it travels no further.
Push the BCM Vertical Grip against rail, engaging the accessory's recoil lugs to the intersecting KeyModT opening.
With the recoil lugs engaged, tighten the screw to snug the anchor (approximately 40 Inch-lbs. plus quarter turn).
Ensure there is no wiggle or forward/backward movement once tight.

Note: Blue thread locker may be used on threaded fasteners